Skid Unit

The unit is in good working condition — it runs, the pump operates properly, and the foam system works as it should. BOOSTER REEL AND HOSE: Hannay electric/manual rewind reel EF20-30-31LT PLUMBING: All plumbing shall be heavy duty schedule 40 galvanized iron with flexible couplings. 1 - Pump drain petcock 1 - 1/4" pump cooling line 750 Gallon Tank VALVES: LOW connections for intake and discharge 1 – 2.5" tank to pump AKRON Brass, quarter turn ball, swing out style. 1 – 2.5" suction with swivel, to rear with plug and chain, commercial Valve 1 – 2.5" Rear Discharge, commercial Valve, with cap / chain 1 – 1.5” Rear Discharge, commercial Valve, with cap / chain 1 – 1.5" tank fill, commercial Valve 3 - 1" to reel, commercial Valve, 2 – at whipline WHIP LINES: Two [2] 1" x 10' booster hose whip lines TANK, FOAM: The integral 10 gallon foam tank FOAM SYSTEM: A Scotty “Through” the pump foam system shall be installed. Foam shall supply to all discharges. FIRE PUMP: CET PFP-20hpHND-MR pump with 20hp Honda engine, range 290GPM@50psi – 45GPM@200psi, with exhaust priming system. C.E.T. single stage centrifugal pump. • Pump body made from high resistant aluminum alloy. • Bronze impeller. • Mechanical shaft seal. • Exhaust priming system, guaranteed up to 20’ (6 meter) lift• Honda 20hp at 3600 RPM, air cooled engine. • V-Twin cylinder gasoline engine. • Electric start. • 36 watt alternator. • Low oil alert. • Pressure gauge. ENGINE FUEL TANK: An independent EPA rated 6 gallon gas fuel tank shall be mounted away from any direct heat source and in a convenient location to provide fuel for the pump engine.